CHANGELOG:

Version 0.1.7:

	Main:
		Decided to try and comment changes better.
			This at least gives a minor insight in to why I did it. I'll mark comments added later with an asterisk.
			
	Software:
		Practically rewrote the main loop.
			Instead of all the switch/case bullshit, I just dump to a variable and make that part of the
			conditional IF statements.
		Bitmapped the logo.
			Fonts are large. The 98x24 bitmap was smaller.
	
Version 0.1.6:

	Software:
		Removed a bunch of functions in favor of passing arguments to function.
			The indvidual functions for setting each input and setting the LCD have largely been combined
			in to one since I figured out how to use arguments. Additional stuff changed/added to accomodate
			this.*

Version 0.1.5:

	Hardware 
		Removed 2003 ground from 595 enable line. (That was a stupid idea that thankfully didn't blow up.)
			I calculated the relays to be 40mA each. Sinking that much current from an IO pin is pushing it, let alone
			the fact I need two relays for phono inputs. 
		Added logic invterter to drive the 595 enable and 2003 ground. (Transistor can sink more current).
			The 2N2222 is rated for like...800mA or something; wayyyy more than I need. In retrospect, this would have been
			a better solution overall than the reset circuit on the 595. Will I change it? I'll have to play with it.
		
	Software:
		Flipped srEnable logic to drive logic inveter added to board.

Version 0.1.4:

	Main:
		Project is now called HiFiLOGIX

	Hardware:
		Tied ULN2003/2803 ground to 595's enable line
			Even with the shift register quiet during boot, the darlington array isn't; and pull-down
			resistors don't seem to help. But I soon realize this is a stupid idea.
		Replaced 1602 display with SSD1306 128x32 OLED
		
	Software:
		Added code to drive OLED display.
		Removed 1602 display code.

Version 0.1.3:

	Hardware:
		Added power-on reset RC circuit to control 595 master reset.
		Removed 595 master reset from Arduino control.
		
	Software:
		Removed 595 master reset commands.
	
	
Version 0.1.2:

	Hardware:
		Wired 595 output enable and reset to Arduino control.
		
	Software:
		Added output and reset commands for 595.
		

Version 0.1.1:

	Hardware:
		Added KY-022 IR module (1838 IR sensor with integrated resistor+led)
		
	Software:
		Added basic support for IR remote control. 
		
		
Version 0.1

	Hardware:
		Added I2C 16x2 LCD Display
		
	Software: 
		Added support for display.
		
		
		
Version Alpha2.1

	Software: 
		Created routine to shift all 0s to 595.
		Added two-relay switching for Phono-1
		Added Phono-2 routine.
		
				
Version Alpha2

	Software:
		Fixed shift register bug from Alpha1.
		Removed serial monitor debugging.
		Cleaned up main loop if statement.
		
		
		
Version Alpha1

	Hardware:
		Initial build. Just switches and LEDs on a 595.
		
	Software:
		Initial offical release. Totally broken.